Find real questions from previous competitive exam papers with answers and solutions.
Leave the keyword blank to browse saved questions for your selected exam, newest papers first. Add a keyword, year or topic to narrow the results.
Browse complete papersAfter leaving the low-pressure cylinder in a two-stage air compressor, where does the air go next?
Back to the atmosphere
To the intercooler
To the high pressure cylinder directly
To the air receiver tank
Correct answer
Back to the atmosphere
What type of measurement does a 'comparator' work on?
Basic measurement
Direct measurement
Relative measurement
Absolute measurement
Correct answer
Basic measurement
Water as a cutting fluid does NOT spread well over a surface to wet it because of _____.
low surface tension
high volatility
high surface tension
high buoyancy force
Correct answer
low surface tension
When selecting an organic coating for a steel structure exposed to outdoor conditions, which combination of properties should be prioritized for effective long-term performance?
Strong adhesion to substrate and high resistance to ultraviolet radiation.
High chemical reactivity and low cohesion with steel to form a sacrificial layer.
Ability to dissolve in water and rapid drying at room temperature.
Low viscosity and low electrical insulation properties in the formulation.
Correct answer
Strong adhesion to substrate and high resistance to ultraviolet radiation.
When selecting a material for a component subjected to cyclic loading and impact, which mechanical property should be prioritized along with hardness?
Plasticity must be considered to increase mass
Ductility must be considered to avoid oxidation
Elasticity must be considered for better insulation
Toughness must be considered to resist sudden failure
Correct answer
Plasticity must be considered to increase mass
In a scenario where excessive spatter occurs during arc welding, which adjustment is most likely to mitigate the issue without compromising weld quality?
Increasing travel speed marginally
Decreasing base metal thickness
Reducing arc length slightly
Switching to a larger electrode
Correct answer
Increasing travel speed marginally
Which characteristic best describes the arc in submerged arc welding?
The arc is completely covered by a layer of flux
The arc is visible and produces bright light during welding
The arc is exposed to the atmosphere during welding
The arc is shielded only by inert gas during welding
Correct answer
The arc is completely covered by a layer of flux
Which of the following is a limitation of conventional oxy-fuel gas cutting?
Cannot cut mild steel plates
Cannot cut thick carbon steels
Requires electrical input for operation
Cannot cut stainless steel efficiently
Correct answer
Cannot cut mild steel plates
Which of the following is a limitation of mechanical comparators?
They cannot measure small deviations
They require electricity
They cannot measure linear dimensions
Mechanical wear can reduce accuracy over time
Correct answer
They cannot measure small deviations
A centrifugal pump is designed to deliver water at a rate of Q = 0.1 m3/s against a total head of H = 25 m. If the overall efficiency of the pump is η = 75%, what is the approximate power input required to drive the pump? (Assume the density of water is ρ = 1000 kg/m3 and the acceleration due to gravity is g = 9.81 m/s2).
58.1 kW
43.6 kW
24.5 kW
32.7 kW
Correct answer
58.1 kW